Jupiter
Slides valves and mouthpiece. Drying the valves can end up leaving small traces of lint on the surface of the valve which can make them stick or slow down later on. Start by running the snake brush through the trumpet tubing. Clean the inside of every valve casing thoroughly. Blow some air through your instrument to check the valves are in the right way.
Use this cloth to polish the instrument and keep clean. After that, you need to use valve oil and a slide grease to add oil to your trumpet exactly when you assemble it. 5. Scrub the valve casings with the straight brush. Place the trumpet's slides in the soapy water and allow them to soak for a few minutes, then use the cleaning snake to clean the insides of the slides.
If your mouthpiece gets stuck while playing, DO NOT attempt to remove it yourself or have anyone else yank it out for you. If you don't grease the slides of your trumpet, the mineral deposits found in saliva will weld the tubes together. The two best brands of soap for cleaning your horn are Palmolive or Joy.
It is important to use valve oil more often than cleaning. Some dish soap and brushes consisting of a snake brush and a pipe cleaner which will be helped you clean your trumpet. After snaking the slides, rinse them with fresh water to remove soap suds, dry and set on a towel.
(The resistance between the water droplets from the rinse and the oil make the water-oil combination a super-slick lubricator, and this is why we cleaned the pistons last, so they could be quickly replaced in the valve casings without losing any of this water-oil combination).
In spite of my careful instruction, it always surprised me how dirty some students would let their mouthpieces get before getting around to cleaning them. Every couple of months, give your valves an oil change. The deposits inside your trumpet are like the mineral deposits on your bathroom walls, water alone will not remove mineral deposits, only acid will.
There might be some dried valve oil in there, but, for the most part, any gunk will be organic (sorry to say) and will dissolve with warm, soapy water and come away with a brush. Place the slides somewhere safe for until the soapy water is ready. You'll use this towel to set the different parts of the trumpet on when you take it apart to clean it.
Start cleaning your mushrooms hours before you use them and you'll have clean dry mushrooms when you're ready to cook. If you must clean the pistons, first, remove the valve caps and felt cushions. First, lay an old towel on the ground or on the table and put your trumpet on top of it. It's best to put a towel down because if valve oil gets onto delicate surfaces, clothing or carpeting, it can cause stains.
It's good idea to move slides every few weeks and grease them every few months, even if the instrument is not being played, because the grease gets stiffer as the volatile components evaporate, and they will eventually get stuck if you abandon them. 4. Rinse the mouthpiece under warm running water, dry with rag, then let air dry for about a minute.
We'll discuss the details of how to clean your horn and specifically how to clean a trumpet mouthpiece and valves below. My trumpet drying off on an old towel. Run the mouthpiece cleaning brush through a couple of times. Place the horn and all the parts in the hot soapy water.
